CURVEDRILL QUICK START
Up and running
in minutes.
The same quick start is built into the app: tap Quick start at the bottom of any screen.
- 1
Sign in
CurveDrill signs you in with a code sent to your email. No password, no license key.
- Open app.curvedrill.com.
- Enter the email you used at checkout.
- Type in the 6-digit code from support@curvedrill.com. No code? Check spam, and make sure it is the same email you bought with.
- 2
Install it
- Android (Chrome): tap Install CurveDrill, or the ⋮ menu, then Install app.
- iPhone (Safari): tap Share, then Add to Home Screen. Sign in from the Home Screen app, not the Safari tab. iPhone help
- PC (Chrome or Edge): click the install icon at the right end of the address bar.
Once installed it works without signal.
- 3
Start a well
On the Wells tab, tap + New well from Excel plan and pick your plan (Excel or CSV). CurveDrill finds MD, Inc and Azi on its own, so plans from most planning software load as they are.
- 4
Finish setup on the Plan tab
The Setup checklist shows anything still missing. Tap an item to jump to it:
- VS direction (checked against your plan)
- Toolface crossover inc (where MWD switches from magnetic to gravity TF)
- Sensor offset, bit to sensor
- Expected motor yield, used until the motor has a measured yield
- Tie-in survey: enter survey depth here, not bit depth
Then tap Continue to Live. After a trip, tap New BHA so the old motor’s yields are not used.
- 5
Log rotation
CurveDrill only needs your rotation. Every foot you do not log as rotation counts as slide.
On the Slide tab, enter Rotated from and To (bit depths) and tap Add rotation. The slide log fills in on its own. Keep the rotation log complete: missed rotation throws off yield, projection and landing numbers.
- 6
Enter a survey
Log that stand’s rotation first. In the Next survey card, check the bit depth, enter Inc and Azm (grid-corrected to match your plan), check the TF used, and tap Enter survey. You type bit depth; CurveDrill subtracts the sensor offset.
- 7
Read the Slide tab
- Bit depth and RINC: update them as you drill. Running yield and the bit projection come from them.
- TFO to plan line steers back to the plan line and landing point. TFO angle only lands the inc and azm.
- Turnazontal: an S-turn landing in two tool faces.
- Slide / rotate: how much to slide and rotate before the next survey, and whether you land long or short of plan.
- More: landing window options (land a few ft high or low) and position vs plan.
Quick tips
- Set the crossover inc before the first survey.
- Type bit depth everywhere except the tie-in, which is survey depth.
- Log rotation every stand.
- Update bit depth and RINC between surveys.
CurveDrill is a calculation aid. Always check against the official surveys, the well plan and your directional company before you act.
Need help? Tap Send feedback in the app or email support@curvedrill.com. Screenshots and a short description help us fix it fast.
